Carrier Access Network Device Axxius 800 Instrukcja Użytkownika Pobierz pdf (Strona 76)

100

101

4-4 Axxius 800 - Release 2.2

Configuration

Basic System Setup

Initial Setup

Use the following commands for your initial setup, for further information see the

specific command listed in Chapter 5, CLI Commands.

NOTE: Removing an active Controller is not recommended, use the

switch controller command to change the Active Controller to Standby and

then remove the Controller card.

Command Description

set date dd/mm/yyyy Set the system date, using the format

day/month/year. See the set date command for

details.

set time {hh:mm:ss} Set the system time. See the set time command

for details.

set id {“id-name”} Set the systemID name. Remember to enclose

this name in quotes. See the set id command for

details.

set clock {nonrevertive|

revertive|switch}

Set the signal clock switching. See the set clock

command for details.

set {clock1|clock2} {source} Set the primary and secondary clock source.

See the set clock (1 and 2) command for details.

set ethernet ip address

{ip-addr} [mask]

Set the Ethernet IP address and optionally the

subnet mask, for the Axxius 800. See the set

ethernet ip address command for details.

set ip gateway {ip-addr} Set the IP gateway for the Axxius 800. See the

set ip gateway command for details.

clear log Initialize the event log. See the clear key

command for details.

status equipment [slot] See the status of the equipment. See the status

equipment command for details.

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 567 568

Komentarze do niniejszej Instrukcji

Brak uwag

Carrier Access Network Device Axxius 800 Instrukcja Użytkownika Strona 76

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking Carrier Access Network Device Axxius 800