Carrier Access Network Device Axxius 800 Instrukcja Użytkownika Pobierz pdf (Strona 194)

100

101

5-94 Axxius 800 - Release 2.2

CLI Commands

set

set lsprotect nonrevertive

Use the set lsprotect nonrevertive command to set low speed protected port(s) to non-revertive

mode.

When a port is in non-revertive mode and a failure occurs the port is switched to the protection

port, and will remain there until manually reset. However, if the port becomes healthy again and

another port has a failure the first port will revert, and the second port will then be protected.

Syntax: set lsprotect {slot:port} nonrevertive [priority]

[1-7]

Example: set lsprotect 5:1 nonrevertive priority 2

{slot:port}

The {slot:port} address of the protected port to be configured.

[priority]

An optional parameter, which defines the port priority in the event that multiple protection

requests are received for the same port number on different cards.

[1|2|3|4|5|6|7]

A parameter set with low speed priority, which sets the value of the port priority. Range is

1-7, default is 7. Priority 1 is the highest priority, 7 is the lowest priority.

slot Slot number (1-8) where a Quad T1 card is located

port Port number or range (1-4)

1 2 ... 189 190 191 192 193 194 195 196 197 198 199 ... 567 568

Komentarze do niniejszej Instrukcji

Brak uwag

Carrier Access Network Device Axxius 800 Instrukcja Użytkownika Strona 194

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking Carrier Access Network Device Axxius 800