Carrier-access Access Navigator Instrukcja Użytkownika Strona 130

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 704
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 129
6-26 August 2003 Access Navigator - Release 1.8
Electrical Installation
Make BITS Cable (Optional)
Make BITS Cable (Optional)
To make an RJ48C timing input cable, perform the following steps (see Figure 6-13).
Follow standard practices for wiring cables.
Use RJ48 connectors.
Use cable rated for Category 3 (CAT3) or better.
Use straight cable wiring, with identical pin connections on both plug ends.
Use twisted pair wires for receive pair.
Use continuity tester to verify pin connections.
Figure 6-13. RJ48C Cable Construction
Connect BITS Cable
Connect RJ48C timing input cable to Timing In connector on rear panel of Access Navigator (see Figure
6-14). Push plug in until it clicks in place.
Figure 6-14. Location of Timing Input (BITS) Connector
Timing Input Jack
(Front View)
1
RJ48C Plug
(Pin Side)
Pins
Pin 1
RingTip
Receive
Twisted Pair
2
RJ48 Plug
Timing In (BITS)
Przeglądanie stron 129
1 2 ... 125 126 127 128 129 130 131 132 133 134 135 ... 703 704

Komentarze do niniejszej Instrukcji

Brak uwag